Industrial Propane Service, Inc.
Industrial Propane Service, Inc.
303 W. Maple St.
P.O. Box 145
Byron, MI 48418 USA
Phone: 800.621.4137
Fax: 810.266.4687
Email: sales@ipsequipment.com
Website: www.whyips.com
Print Back

Designed especially to provide pull-away protection for LP-Gas and anhydrous ammonia transfer operations including transport and delivery truck loading and unloading, engine fuel container filling and miscellaneous cylinder filling operations. When properly fastened to the inlet end of the discharge hose, the valve is designed to stop gas escape from both upstream and downstream lines in the event of a pull-away. An excessive tension pull causes the valve to automatically separate, closing two internal back pressure checks. Only a few cubic centimeters of gas escape at the instant of separation.
Unit of Measure

Specifications

Inlet Connection Size

 N/A 3/4 in

Inlet Connection Type

 N/A Female National Pipe Thread (FNPT)

Outlet Connection Size

 N/A 3/4 in

Outlet Connection Type

 N/A Female National Pipe Thread (FNPT)

Approximate Disconnect Force

 N/A 130 lb

Approximate Reconnect Force

 N/A 80 lb

Length of Valve

 N/A 3 7/8 in

Rating

 N/A Underwriters Laboratories (UL®) Listed

Alternate Part Number

 N/A A2141A6L

Size

 N/A 3/4 in

Material

 N/A Ductile Iron

Liquefied Petroleum (LP) Gas Flow Capacity

Liquefied Petroleum (LP) Gas Flow Capacity at 5 Pounds Per Square in Gauge (psig) Pressure

 N/A 11 gpm

Liquefied Petroleum (LP) Gas Flow Capacity at 10 Pounds Per Square in Gauge (psig) Pressure

 N/A 16 gpm

Liquefied Petroleum (LP) Gas Flow Capacity at 25 Pounds Per Square in Gauge (psig) Pressure

 N/A 25 gpm

Liquefied Petroleum (LP) Gas Flow Capacity at 50 Pounds Per Square in Gauge (psig) Pressure

 N/A 36 gpm

Additional Information

Additional Information

 N/A

It is recommended that a convenient means be provided to safely remove the pressure from the line upstream of each coupling half to enable reassembly of the valve. To reassemble, simply push the male half firmly into the female half until the retaining balls slip into the retaining groove. Check for leaks after reassembly.

Note

Note

 N/A

It is recommended that pull-away valves be maintained and safety tested periodically to confirm that they will separate properly in the event of a pull-away. Lubrication every six months is essential to the pull-away's operation. Dry nitrogen or other inert gas is suggested as a source of pressure for pull-away tests.

If the A2141 pull-away valve is going to be stored for a period of time, A2141 Series such as in seasonal applications, it is recommended that it be sprayed with a good grade of rust-preventive machine oil, and covered to protect it from moisture.