Industrial Propane Service, Inc.
Industrial Propane Service, Inc.
303 W. Maple St.
P.O. Box 145
Byron, MI 48418 USA
Phone: 800.621.4137
Fax: 810.266.4687
Email: sales@ipsequipment.com
Website: www.whyips.com
Print Back
Motor speed pumps for multi-station cylinder filling, motorfueling, low volume transfer and vaporizers.
Unit of Measure

Specifications

Factory Relief Valve Setting

 N/A 150 psi10.34 bar

Pump and Motor Speed

 N/A 1,150 rpm1,750 rpm

Maximum Differential Pressure

 N/A 150 psi10.34 bar
Maximum Working Pressure1 N/A 350 psi24.13 bar

Note for Maximum Frame Motor Size for Mounting on Standard Base

 N/A Motors may be specified from Electric Motor Price List No. 10-MTRG-01 (explosion-proof manual start switch for 1 & 1-1/2 horsepower single-phase motors also available).

Approximate Delivery of Propane at Differential Pressures and Pump Speeds

Flow Rate (Approximate Delivery of Propane at Differential Pressures and 1,750 Revolutions Per Minute (rpm) Pump and Motor Speed at 50 Pounds per Square Inch (psi) (3.45 Bar))

 N/A 33.0 gpm124.9 L/min

Flow Rate (Approximate Delivery of Propane at Differential Pressures and 1,150 Revolutions Per Minute (rpm) Pump and Motor Speed at 50 Pounds per Square Inch (psi) (3.45 Bar))

 N/A 20.0 gpm75.7 L/min

Flow Rate (Approximate Delivery of Propane at Differential Pressures and 1,750 Revolutions Per Minute (rpm) Pump and Motor Speed at 100 Pounds per Square Inch (psi) (6.89 Bar))

 N/A 29.0 gpm109.8 L/min

Flow Rate (Approximate Delivery of Propane at Differential Pressures and 1,150 Revolutions Per Minute (rpm) Pump and Motor Speed at 100 Pounds per Square Inch (psi) (6.89 Bar))

 N/A 17.0 gpm64.4 L/min

Note for Approximate Delivery of Propane at Differential Pressures and Pump Speeds

 N/A Check the pump's delivery and brake horsepower requirements in the performance curves below. Footnote with the curves which explains the factors that can cause delivery to vary.

Motor Size

Minimum Frame Motor Size for Mounting on Standard Base2 N/A 56C

Maximum Frame Motor Size for Mounting on Standard Base

 N/A 215C
  • 1 Maximum rated working pressure is 350 psi (24.13 Bar) for LPG and NH3 (limited by U.L. and N.F.P.A. 58).
  • 2 Motors may be specified from Electric Motor Price List No. 10-MTRG-01 (explosion-proof manual start switch for 1 & 1-1/2 horsepower single-phase motors also available).