Request Information

Dot Fork Lift Service Valve For Cylinders - 1/4" NPT Withdrawal Connect. - 2.6 Gpm

Unit of Measure

Connection

Container Connection Size

 N/A 3/4 in

Container Connection Type

 N/A Male National Gas Taper (MNGT)

Service Connection Size

 N/A 3/8 in

Service Connection Type

 N/A Male National Pipe Thread (MNPT)

Liquid Withdrawal Connection Size

 N/A 1/4 in

Liquid Withdrawal Connection Type

 N/A Male National Pipe Thread (MNPT)

Closing Flow

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 25 Pounds Per Square in Gauge (psig) Inlet Pressure

 N/A 550 scfh

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 100 Pounds Per Square in Gauge (psig) Inlet Pressure

 N/A 1,050 scfh

Specifications

Liquid Flow Capacity

 N/A 2.6 gpm

Rating

 N/A Automatic Certificate Management Environment (ACME) Department of Telecommunications (DOT) Underwriters Laboratories (UL®) Listed

Material

 N/A Brass

Alternate Part Number

 N/A 9101P6H

Liquid Filling Rates

Approximate Filling Rate Liquid Flow at 10 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

 N/A 4.5 gpm

Approximate Filling Rate Liquid Flow at 25 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

 N/A 7.2 gpm

Approximate Filling Rate Liquid Flow at 50 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

 N/A 10.3 gpm

Approximate Filling Rate Liquid Flow at 100 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

 N/A 14.8 gpm

Accessories

Accessories

 N/A

Part Number - 7141M
Part Name - Male Automatic Certificate Management Environment (ACME) Check Connectors

Part Number - 7141F
Part Name - Female Automatic Certificate Management Environment (ACME) Check Connectors

Part Number - 7141M-40/7141FP
Part Name - Cap

Additional Information

Additional Information

 N/A

When installed for liquid withdrawal, the 9101P6 Series has provisions for attachment of a liquid withdrawal tube. The 9101P5 Series must be installed in containers that have provisions for a separate liquid withdrawal.

To ensure proper functioning and maximum protection for integral excess flow valves, these service valves should be fully opened and back seated when in use.

Note

Note

 N/A

These valves incorporate an excess flow valve. Refer to L-500/Section F, for complete information regarding selection, operation and testing of excess flow valves.