Dot Fork Lift Service Valve For Cylinders - No Withdrawal Connect. - 1.5 Gpm

Unit of Measure

Connection

Container Connection Size

N/A 3/4 in

Container Connection Type

N/A Male National Gas Taper (MNGT)

Service Connection Size

N/A 3/8 in

Service Connection Type

N/A Male National Pipe Thread (MNPT)

Liquid Withdrawal Connection Size

N/A None

Closing Flow

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 25 Pounds Per Square in Gauge (psig) Inlet Pressure

N/A 430 scfh

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 100 Pounds Per Square in Gauge (psig) Inlet Pressure

N/A 900 scfh

Specifications

Liquid Flow Capacity

N/A 1.5 gpm

Rating

N/A Automatic Certificate Management Environment (ACME) Department of Telecommunications (DOT) Underwriters Laboratories (UL®) Listed

Material

N/A Brass

Alternate Part Number

N/A 9101P5

Capacity

N/A 1.5 gpm

Liquid Filling Rates

Approximate Filling Rate Liquid Flow at 10 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

N/A 5.0 gpm

Approximate Filling Rate Liquid Flow at 25 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

N/A 7.6 gpm

Approximate Filling Rate Liquid Flow at 50 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

N/A 10.7 gpm

Approximate Filling Rate Liquid Flow at 100 Pounds Per Square in Gauge (psig) Pressure Drop Across Valves

N/A 14.9 gpm

Accessories

Accessories

N/A

Part Number - 7141M
Part Name - Male Automatic Certificate Management Environment (ACME) Check Connectors

Part Number - 7141F
Part Name - Female Automatic Certificate Management Environment (ACME) Check Connectors

Part Number - 7141M-40/7141FP
Part Name - Cap

Additional Information

Additional Information

N/A

When installed for liquid withdrawal, the 9101P6 Series has provisions for attachment of a liquid withdrawal tube. The 9101P5 Series must be installed in containers that have provisions for a separate liquid withdrawal.

To ensure proper functioning and maximum protection for integral excess flow valves, these service valves should be fully opened and back seated when in use.

Note

Note

N/A

These valves incorporate an excess flow valve. Refer to L-500/Section F, for complete information regarding selection, operation and testing of excess flow valves.