ASME Motor Fuel Service Valve Heavy-Duty - 3/4" M.NGT x 3/8" SAE Flare x 1/4" NPT

Unit of Measure

Connection

Container Connection Size

N/A 3/4 in

Container Connection Type

N/A Male National Gas Taper (MNGT)

Liquid Withdrawal Connection Size

N/A 1/4 in

Liquid Withdrawal Connection Type

N/A National Pipe Thread (NPT)

Closing Flow

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 25 Pounds Per Square in Gauge (psig) Inlet Pressure

N/A 550 scfh

Vapor Closing Flow (Liquefied Petroleum (LP)-Gas) at 100 Pounds Per Square in Gauge (psig) Inlet Pressure

N/A 1,050 scfh

Note for Closing Flow (Liquefied Petroleum (LP)-Gas)

N/A

Based on 3/8" O.D. pigtail; 20" long or less, connected to valve outlet. Also based on 1/4" pipe size dip tube, 42" long or less, attached to special inlet connection. For longer pigtail lengths, the diameter of the pigtail must be increased.

Specifications

Liquid Flow Capacity

N/A 2.6 gpm

Rating

N/A American Society of Mechanical Engineers (ASME) Underwriters Laboratories (UL®) Listed

Material

N/A Brass

Alternate Part Number

N/A 9101H6

Size

N/A 3/4 in

Additional Information

Additional Information

N/A

When installed for liquid withdrawal, the 9101H6 has provisions for attachment of a liquid withdrawal tube. All other valves must be installed in containers that have provisions for a separate liquid withdrawal.

To ensure proper functioning and maximum protection from integral excess flow valves, these service valves should be fully opened and back seated when in use.

Note

Note

N/A

Heavy-duty models

These valves incorporate an excess flow valve. Refer to L-500/Section F, for complete information regarding selection, operation and testing of excess flow valves.